CR2000 Series

Templates/Spec Sheets | Part Numbers and Descriptions | Print Catalog Page

Saddle Thresholds

  • FASTENERS - #10 x 1-1/2" wood screws, other screw types and anchors available upon request
  • OPTIONS - Available with Sure Step Non-Slip Abrasive Coating
  • BACKSET - 2 3/4" Standard, 2 3/8" available upon request.
  • MIL finish thresholds are supplied with zinc plated screws
  • Brass thresholds are supplied with brass screws
  • Color anodized thresholds are supplied with screws plated to match
  • Stainless steel thresholds are supplied with stainless steel screws

Certificates:

Underwriter's Laboratories
Products denoted by this symbol are classified and labeled by Underwriter's Laboratories, Inc. as gasket materials for use on listed steel frames and/or classified swinging type fire doors of the hollow metal or steel covered composite type rated up to 3 hours, or wood core fire doors rated up to 1-1/2 hours. Test results show that these products do not affect the fire resistance of the door or frame according to its UL rating. All products are regularly checked under a labeling and listing service. The clearance between the door and the frame and between the meeting edges of doors swinging in pairs shall be 1/8" +/- 1/16" (3.18 mm +/- 1.59 mm) for steel doors and should not exceed 1/8" (3.2 mm) for wood doors.


Positive Pressure UBC 7-2 (1997) Part 1
UBC 7-2 (1997) designates that the product has been positive pressure tested to the new standard. Part I of this symbol designates the fire test. Since this symbol is used to designate the positive pressure fire test and does not differentiate between categories "G" and "J", additional information is needed. Products intended for use as edge sealing systems needs to be labeled as such or list category "G" in their literature. Without this information, the product is category "J"; fire tested to the new standard of positive pressure.


Handicap Accessibility
Products denoted by this symbol are designed for applications where handicap accessibility is specified. These products are no greater than 1/2" (12.7 mm) in height and have no more than 1/4" (6.3 mm) vertical rise or with slop proportions no greater than 1:2 slope. Offset floor conditions greater than 1/2" (12.7 mm) require a 1:12 slope.

Drawings or illustrations used in the catalog are subject to change without notice. Questions on any dimensions should be obtained by contacting Cal-Royal Products, Inc. Customer Service.